What is Electronic Program Guide Offset?

EPG offset is the per-channel or global time shift a player applies to XMLTV timestamps so programmes align with the local clock. Because feeds are produced in UTC or the broadcaster timezone, channels from other regions often display 1-9 hours off.

No. Changing the clock breaks HLS segment windows and catch-up; always use the EPG shift setting.

Run a speed test on the same device while a stream buffers. If raw throughput is above 25 Mbps but the player reports a bitrate below 8 Mbps, your ISP is applying traffic shaping to the stream flow, usually triggered by deep packet inspection of the TLS SNI or by sustained UDP/TCP flows to known hosting ASNs. Stop it by routing the player through a WireGuard tunnel (which hides destination and SNI inside ChaCha20-Poly1305 encryption), switching DNS to 1.1.1.1 over HTTPS, and keeping a 5,000 ms player buffer so short shaping bursts never reach the decoder.

Set the largest option (5,000 ms in TiviMate, "Large" in Smarters). Buffer time in seconds equals buffer bytes multiplied by 8, divided by the stream bitrate in Mbps: a 15 MB allocation on an 18.5 Mbps 4K feed yields 6.5 seconds of protection, which covers typical ISP shaping bursts of 2-4 seconds without a visible freeze.

Players fetch an XMLTV file from xmltv.php and match each channel by tvg-id. An empty guide means the player downloaded the file before the server finished its 15-minute refresh or the file exceeded the player size cap (set TiviMate EPG update to "never limit"). Wrong times are a timezone offset issue: XMLTV timestamps carry +0000 and the player must apply your local offset, so set an EPG shift of +1 or -5 hours in the channel settings rather than changing the device clock.

Stalker / Ministra middleware authenticates a set-top box by its 48-bit MAC address (MAG boxes use the 00:1A:79 OUI prefix) instead of a username and password. The reseller panel binds that MAC to a subscription line; apps such as IBO Player and Smarters on Samsung or LG TVs generate a virtual MAC that must be registered the same way. If you replace the device, the panel must re-bind the new MAC or the portal returns an "unregistered device" error.

WireGuard. It runs in the Linux kernel, uses a 4,000-line codebase with ChaCha20-Poly1305 encryption, and adds roughly 1-3 ms of latency with 5-8% throughput overhead, so an 18.5 Mbps 4K stream passes untouched. OpenVPN in TCP mode suffers from TCP-over-TCP meltdown during packet loss and typically costs 20-35% throughput; use OpenVPN only in UDP mode with tls-crypt on networks that block UDP port 51820.